Unable to install the clutch disc to the main drive shaft
- Contact mark on the teeth of spline and the end of hub
- Burrs at the end of hub due to uneven wear on the spline teeth
- Damaged torsion springs
- Damaged facing material
- Oily facings
- Broken facings
- Wear out on teeth of spline / Cushion spring steel segments separated from hub area
- Rust on the teeth of spline hub
- Unable to install the clutch disc to the main drive shaft
- Dropout of torsion spring/wear out of stop pin
- Hit mark to spline teeth and end surface. Crack to clutch plate.
Cause
•Spline specification is different from main drive shaft form.
•Clutch disc is not matched to the car. Not checked carefully before installation
Solution
•Check carefully with this catalogue for getting right part number.
•Insert the disc to the shaft temporarily and check if it moves smoothly on the shaft.
Back to List