Damaged facing material
- Contact mark on the teeth of spline and the end of hub
- Burrs at the end of hub due to uneven wear on the spline teeth
- Damaged torsion springs
- Damaged facing material
- Oily facings
- Broken facings
- Wear out on teeth of spline / Cushion spring steel segments separated from hub area
- Rust on the teeth of spline hub
- Unable to install the clutch disc to the main drive shaft
- Dropout of torsion spring/wear out of stop pin
- Hit mark to spline teeth and end surface. Crack to clutch plate.
Cause
Clutch disc has been dropped possibly during installation or damaged in transit. Bulged clutch facing to contact flywheel causes this problem.
Solution
Always check before installation that is intact.
Treat parts carefully.
Back to List