Contact mark on the teeth of spline and the end of hub
- Contact mark on the teeth of spline and the end of hub
- Burrs at the end of hub due to uneven wear on the spline teeth
- Damaged facing material
- Rust on the teeth of spline hub
- Dropout of torsion spring/wear out of stop pin
- Hit mark to spline teeth and end surface. Crack to clutch plate.
Cause
Excessive force to fit a main drive shaft causes this problem during reinstallation of transmission.
Solution:
During the installation of transmission, align drive line;
-height
-angle
-spline teeth
then fit without excessive force.
Back to List